remo+

remo+ RemoBell S Power Kit

remo+ RemoBell S Power Kit is rated 4.8 out of 5 by 6.

$20.00

Description

The remo+ Power Kit helps connect your existing doorbell chime with RemoBell S.

Installation Instructions:

Insert one end of the Wire Harness into the Power Kit.
Remove the cover of your mechanical chime.
Take a picture of the existing wiring for reference during installation
Loosen the screws and remove the wires. Then straighten the exposed end of the wires.
Connect the Wire Harness to the "TRANS" and "FRONT" chime terminals.
Insert an exposed end of the Wire Harness and one chime wire into the Wire Nut, and twist it tightly. Repeat with remaining wires.
Place your Power Kit so that it doesn't interfere with moving parts or muffle the chime. You can use the adhesive backing to hold it in place. Put the chime cover back on.

More from this collection

Certified Refurbished RemoBell S Smart Video Doorbell Camera - Remo+

Certified Refurbished RemoBell S Smart Video Doorbell Camera by Remo+

Regular price $69.99

Indoor Chime by Remo+

Regular price $29.99

Extended Warranty

From $19.99

Certified Refurbished DoorCam™ 2 BUNDLE by Remo+

From $169.99

Rated 5 out of 5 by BillyBillyBilly from Works great Works great. I had to order a second adapter for my second door bell. Best deal going.

Date published: 2019-10-10

Rated 5 out of 5 by Anonymous from

Date published: 2019-11-03

I just installed the doorbell. It works well, but my mechanical chime no longer goes off when the doorbell rings. I checked the wiring, it is connected correctly. Any advice? 

Asked by: Jake N

I have the same problem.

Answered by: Avargaz

Date published: 2020-12-19

My home voltage is 220v, can the powerkit work properly?

Asked by: Anonymous

I have a front and rear chime wiring connection - should I disconnect the rear connection?

Asked by: HarryelHat

If you would like to install 2 chimes to one RemoBell S you will need to purchase an additional power kit from remoplus.co as each chime will need its own. Please email support@remoplus.co with your registered email address and a picture of your chime setup for further assistance.

Answered by: Remo+

Date published: 2020-12-02

Can two Remo S doorbells be used on 1 non mechanical chime?  If so is all that’s required is another power adapter can it be added inline with the existing power adapter and chime?  Is there a diagram that I could follow?

Asked by: NewToRemo

Just this part come with the remote doorbell when you buy it

Asked by: Smile

Hello, There are other accessories that come in the box that requires installing the Remobell S. Thank you.

Answered by: Jenil

Date published: 2020-11-12

I believe I wired the power kit correctly to my mechanical doorbell; went through the instructions twice. But when I turn on the power at the breaker, the top solenoid makes a noise and becomes too hot to touch.

Asked by: wendy907

What if I don't have an existing doorbell and I buy a chime what parts do I need to make a compatible

Asked by: Smile

Hello, It's kind of hard because if you don't have an existing doorbell you would have to run all wires going through your house to your electric panel wherever that is located. I would recommend consulting a certified eletrican. Thank you.

Answered by: Jenil

Date published: 2020-11-12

I have 3 wires to my door bell chime. I installed the power adapter to one of the wires from the transformer and the other from the door bell. The power box is warm. The other wire comes from the door bell as well. Is this correct?

Asked by: Craig s